What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 29.06.2025 08:10

eight
2024–10–10[John johnson John Johnson ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Is it possible to run away from home at 16? What are some essential items to bring for survival?
But it can get overloaded, and no longer works.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Oldest human DNA ever found tells the story of a lost branch on the human family tree - Earth.com
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It seems Mohan does not understand the difference between a comment and an Answer.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Is the Philippines PH a poor 3rd world or 4th world country forever and forever?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The other is “what does a “fuse” do?”
Here is a simplified AC power diagram.
Which new book genres have emerged in the past decade?
He then asserts :
One is “what exactly is in a ‘surge protector’ ? ”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Trump says 'it's possible' US gets involved in Israel-Iran conflict - ABC News
For this case there are devices called Metal oxide varistors (MOV).
Now when you have a certain ac resistance, then a current flows in a loop.
[old diagram got deleted by accident]
What are the best ways to treat seasonal allergies?
Barnstars:
what exactly is a ‘surge’ protector?
This is where this question deviates from being a 'generic' question, and becomes more specific.
How would you feel if your girlfriend had dick pics on her phone?
a photo is worth a thousand words.
What does a fuse do?
This one hit behind the barn.
Upvotes:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The bolt then partially travels down the line to your home.
Because the load is inductive, the current lags the voltage.(by a bit).
the problem then depends on "how fast does the fuse operate?".
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Why do you think Democrat favorability ratings are so low?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Four measles cases confirmed in Navajo County, first in Arizona this year - ABC15 Arizona
This device then solves the entire problem.
An AC voltage/ current source, and an ac inductive load.
This is where the MOV conducts again, and dissipated the energy.
Microsoft Copilot flaw raises urgent questions for any business deploying AI agents - Fortune
There are three different concepts here that are getting confused.
These devices are installed between the “hot” and “neutral” and protective ground.
A circuit breaker is similar, but is resettable.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
[image of Common-mode choke]
But… the neutral is now “floating” because of the 1 ohm resistance.
He then describes the function of a fuse.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The third is lightning and “how it gets conducted into a home.”
This is 'the assistant's answer'
2024–10–14 [Omar Gharbi Omar Gharbi ]
but I think this circuit , shows a few more pieces.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At one ohm, the resistor has a maximum of 1 watt power.
A fuse is a non-resetable over current circuit protector.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
He then describes Rainy Season and Lightning.
These are simplified answers to the original question, and does not change anything I wrote above.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
nine
What is lightning?
(Dc diagram shown, AC is similar).
but this device (an Inductor) … impedes the rapid changes in the current.
First Sentence:
It also is a device that limits the change in current flow.
I post the exact comment here.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
One
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
In schematic diagrams this is the symbol for a fuse:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
There are two important concepts here.
2024–10–16 [ OO OLAOYE OYEBODE ]
Edit 2024–10.
At least they know the answer if they wanted it.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.